- Joined
- Mar 2, 2011
- Messages
- 692
- Points
- 0
I'm gona be building my self a few benboost drivers.
I ordered lastest revision of the board.
If I wanted, could I leave out the fet and just solder across the pads?
As long as I dont reverse the polarity this should be fine right?
as well as boosting the efficency by a wopping 1% lol
Link the the ben boost thread
I ordered lastest revision of the board.
If I wanted, could I leave out the fet and just solder across the pads?
As long as I dont reverse the polarity this should be fine right?
as well as boosting the efficency by a wopping 1% lol
Link the the ben boost thread