5W 455nm(NUBM08 with Gball-G7 lens)

[trinh hong phuoc]

HI LPF,this is my new build
i use NUBM08 diode ,driver from xwossee at 4,5A,convoy S2+ host with copper module and brass heatsink
this is my video

 

[reloader45]

Hello,

very nice laser!

I would be interested, how you made the connection to the batterie?

As a beginner in laserpointer i have problems to get good quality switches and conection boards.


best regards

Edgar

 

[Lifetime17]

Hi
Basically just solder two wires to the driver correct polarity
Rich

 

[RedCowboy]

I have discovered how to get tight solder connections like DTR
Strip only about 1mm off your silicon wire and put it into your driver board hole, then solder with the wire not quite sticking out of the hole, let the solder flow into the hole and copper wire but don't cook your driver, I use Kester "44" .8mm solder.
I have been getting good clean connections that don't short when bonding the drivers 8 pin chip to my case.


I like how your heat sink is flush with the convoy so it's all the same diameter, this is what I want.

I would like to buy some convoy with this brass heat sink like this, maybe make the brass sink twice this length.

 

[Lifetime17]

Hi
Red
That’s how I solder wire to my driver.

Rich

 

[trinh hong phuoc]

RedCowboy

I'm sure Rick can do that, people in my country always like brass because it's cheap, nice, but I've always wanted to use aluminum or copper.

Edit: making such output will make the host more harmonious, which will probably be the destination in my future builds

Lifetime17 I think he's asking about this

this is 17mm contact broad,it is driver 7135 but just is broad,5Ampe is okay for it
reloader45
i will show you how i can contact with batterry,maybe in next build(5-10days more)
Thank all

 

[Juntendo]

Where did you get your copper heatsink from? is it custom made?

 

[Lifetime17]

Hi,
I haven't seen this member posting in a while maybe he will check in to answer your question .
Rich