- Joined
- Dec 24, 2013
- Messages
- 49
- Points
- 0
Any ideas on a driver that would power this. I'm seeing about 14.4amps
Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers
Buy Site Supporter Role (remove some ads) | LPF Donations
Links below open in new window
FrozenGate by Avery
445nm 'handheld' design
- Thread starter DoctorEvil
- Start date
- Joined
- Dec 29, 2009
- Messages
- 3,136
- Points
- 63
put your diodes in series. Should be easier.
- Joined
- Dec 24, 2013
- Messages
- 49
- Points
- 0
Okay then that makes it how many volts ideally? I am unsure what the magic voltage for m140s are. Somewhere between 4-4.5 I'd gues it'd be better to go lower than higher in case something bad happens. If 4 is good then 4*8=32volts. What will do that if that's right