- Joined
- Nov 4, 2013
- Messages
- 40
- Points
- 0
Edited
Last edited:
Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers
Buy Site Supporter Role (remove some ads) | LPF Donations
Links below open in new window
FrozenGate by Avery
405nm Laser Driver Wich should I get?
- Thread starter BlackFire007
- Start date
- Joined
- Dec 23, 2008
- Messages
- 3,948
- Points
- 63
the driver kind of depends on your host. is it a single battery host? if so you need a boost driver. is it a multi batt host, then possible a linear or buck, or use spacers. what lens are you using? in other words you don't give enough info for anybody to actually help you
Michael.
Michael.
- Joined
- Nov 4, 2013
- Messages
- 40
- Points
- 0
Edited
Last edited:
- Joined
- Dec 23, 2008
- Messages
- 3,948
- Points
- 63
I'd recommend a flex drive microboost, or a x-boost. check out dtr's site in the pro shop, or click the bottom links in any one of the threads he's posted in.
Michael.
Michael.
- Joined
- Aug 14, 2013
- Messages
- 2,640
- Points
- 63
There are round X-Boost™, but it comes in 2 sizes and you have to figure out which one you need. C6 I
think is 16mm, but I'm not 100% on that, maybe somebody else can chime in. The round ones go out of
stock frequently, so you can also get what is called a contact board and solder a square driver to that.
The thing about the X-Boost™ is that they NEED a heatsink on the driver chip itself or else it will smoke.
think is 16mm, but I'm not 100% on that, maybe somebody else can chime in. The round ones go out of
stock frequently, so you can also get what is called a contact board and solder a square driver to that.
The thing about the X-Boost™ is that they NEED a heatsink on the driver chip itself or else it will smoke.
