yobresal
0
- Joined
- Nov 5, 2007
- Messages
- 4,919
- Points
- 83
I have 2 of these for sale. They are both beautiful hosts. They each already have a M140 diode installed. They also have the G2 lens installed. They are complete builds with the FMT drivers installed. I have yet to build a laser with these drivers that has been able to operate properly. I do not know what (if any) batteries to use with these lasers to give the drivers the power they require to regulate properly. As is the lasers put out over 1W but they do not put out the 2W+ that they should. What I would do if I were the buyer is open the lasers, remove the drivers, install a different boost driver set up (be it single or dual driver) and have yourself a sweet build. Then again you may want to buy a few different batteries and see if you can find some that will work properly. I am going to include at least one battery with each laser. One uses the 32650 and the other uses the 26650 battery.
Asking price is $150 shipped each.
This is less than the cost of the parts excluding the drivers so it really is a good deal. I just want to get these off of my workbench and into the hands of someone who is ready to give them the attention they need. Thanks.
Asking price is $150 shipped each.
This is less than the cost of the parts excluding the drivers so it really is a good deal. I just want to get these off of my workbench and into the hands of someone who is ready to give them the attention they need. Thanks.
