Search results

1 mil poster should get some sweet forum thing. Like special rights or a something lol

http://www.rccombo.com/en/rc-motor/2259-scorpion-hk-7050-340kv-brushless-outrunner-motor-hk7050340.html

Not bad for 5Ah. My venoms were more than twice that a piece lol

There are two types of people in this world, those that do and liars.

It's the same as the protox. I have this copter. Pretty fun to fly and damn it's tiny.

As soon as you fly the hubsan you will want a quad or a hex a octaquad or if you're like me an octacopter :)

Its the Boscom 500mW 5.8 transmitter with a generic receiver. (soon to upgrade antennas for better distance and signal quantity. Hooked to the gopro (obviously) and then feeding a 5 inch lcd on my radio. The ESC rating is average rating. Mine are 20A but can easily run 40 or so amps for short...

Update to the flying lawn mower. Added a tilt mount for the gopro. Will be switching this to a board camera soon so there isnt that much stress on the servo. Also will allow me to finally put my gopro back in its case and just have it sitting up above the avionics rack for filming and the board...

I picked up a controller from eBay for like 30$. Supports a decent current draw with a wide range of voltage inputs. It's what turns my led on.

Before it goes out of range you won't be able to see the copter. I've had mine out to about a quarter mile but turned back because my fpv feed was getting grainy. 5.8ghz blows :(

You can solder on new connectors :) I'm running 5Ah 3 cells. May run both in parallel for 25 min flight time :) yup. All that will get you flying. Though I would recommend adding some props to that list :)

May need battery connectors on either your lipo or copter so they match. I'm running the connectors or deans. A lot of lipos are coming with bullet connectors and most recently vehicles I have seen don't use those.

The turning is the same as mine and the throttle is the standard stay where you leave it.

Well the light from the ktp is colminated through the OC but has that very nice round dot.

Not until you can see the beam extending and extending as the photons travel will I be impressed! JK. If you have a mirror and a small motor make a Spiro graph and film that in slowmo

Let me know!

Higher quality leads are always better and will cost more. Though with the lake of specs on them I doubt this is the case. If someone will buy it then they will keep listing it at that.

It is probably a factor of poor QC. Most of the green modules I have the beam exits at a slight angle. Its just the nature of the cheap DPSS modules.

How did your name get approved? Anything that burns you will need glasses. Simple and to the point. Eye safe is 5mW

None what so ever. If you get the hubsan i can tell you how to calibrate it with a stick positioning. There are like 12 hubsans it seems now. Lol. Even one with fpv! But that's pricey. The protox has fantasticly bright leds on it so you know which way it's facing. Real really bright for its...