Search results

I am unsure on how to post..... i cant find the button or where i would click

Cant remove it thinking about making a precision cut what do you think?

ok just soldered it on the chip where the two wires went it said temp{ so im gueing thats a temp gauge or somthin but other than that turned it on still same tiny glow if i pput IR filter and what not back on would it make it visible?

Now what exactly does it mean DPSS?

found two wires on circuit board that have hardly any wires left in the solder think this is the culprit? i just cant see how they would have been affected by dropping the laser

and can i bump this to get more attention to it and if so how?

I do not know if i can remove from rear i wonder if they put it together in 3 different sections here is what my dilemma in the front is

yes i am actually quite skilled at that unlike my knowledge of diodes and etc.

the wiring i believe or on the picture of the of the front where the IR is displayed you can see a lip on the tube where screws are partially under the lip should i approach from front or back?

i could get it out it would for sure break tho so i need to know if it not repairable i understand its hard to tell me indefinably

it was a very dim green laser i looked at it through my phone camera for the IR i think it is out of alignment it looks shifted hard to describe any other comments?

Anything you guys need to look at in depth let me know ill get a pic

i hate to keep you guys waiting just dont have time today i wish i did but theyll be uploaded shortly like tommorow :yabbem:

it say pictures are too big how do i upload

can i use the housing?

I have taken it apart i will take pictures when i get back to my shop, expect them lets say Saturday you guys have been great lots of knowledge i wasn't even expecting a response hey if we cant fix it perhaps we will make a frankenlaser :beer:

would the installation be a challenge?

hmmmm what do you think a new diode would run or could i get a step down?

i see and there is no way of aligning or properly fixing this?

whats a module? the switch and all the operations are in working order