Thank you for liking one of my lasers.
I've been doing panel joints since I was a kid, although I draw boards at work and have them done in JLCPCB. However, at home I make them using etching.
Sure, the board would want to accommodate stronger components like mainly diode, inductor, low ESR...
Hey, everybody,
This is probably my first post so I'd like to show my better side. I would like to show my latest project regarding lasers. It's a 520nm 750mW laser.
It is completely my design including 3D prints, switched CC converter and complete test and diagnostics. Before I get to the...
Interests: Electronics, High Voltage, Lasers, Physics
Interesting facts about me: I am an electronics engineer primarily involved in power supplies, building Tesla Transformers, laser design, and exploring the principles of light sources.
My biggest builds: a QCW-DRSSTC, 4W 450nm. Laser + 2S...
I guess we didn't understand each other... I'm definitely not someone who doesn't understand switching power supplies and current sources, so I don't understand the nonsense you write here :) I as a developer know very well what works and I only asked what this power supply works on and since I...
Oh, well :D it sounds quite funny when you write here that it's development as if it's for the army. I'm an electronics engineer and I design many more complex projects around switching power supplies and you're bragging about something that's straight from DataSheet.. how funny, however if...
I don't know what's so complicated about it... Found some IC Buck-Boost on Farnell, Mouser etc.. then drew it in KiCad and made PCB... In two hours done. Anyway, thanks for the reply.
PS: Will you grind the type designation of the IC? :D
Hi, :)
What kind of IC are you using? I'm thinking of a lot of ways of Buck, Buck-Boost and Boost converters for which I make my own designs so out of curiosity I'm asking what you use here.
For the future though, I'll show a couple of inverter types for given laser diode types and different...