I received my 6x pair from Opt Lasers. Using the 6x pair by itself gave me a decent spot from a NUBM44. I tried combining a 6x with a 4x from LSP but 24x was a bit too much. I could not get a spot regardless of lens position. Just an ugly line and lots of splash. I might purchase a 3x from...
Hello all,
I have been monitoring this thread off and on for some time now. I have a 4x lens pair from Lasershow Parts that I have been experimenting with using a NUBM44 diode. I just purchased a 6x pair from OPT Lasers and will be experimenting with that pair as well as combinations of the...
Here is my latest... a Nichia NUBM44 at ~6.8 watts housed in a Solar Force L2 host via a custom heat sink module from JayRob. This one was a pain in the butt to build as I had to undo a lot of Jordan's beautiful solder connections to install the module and driver into the heat sink module. I...
Hi all,
I was distracted one day by an ad for the Glow Forge 3D laser printer so I went to their site and while looking at the specs I saw it used what was described as a 10,600nm 40 watt CO2 laser to do the cutting. My question is does a 10,600nm wavelength exist or is that a misprint?
Hi Jay,
Are you still making the L2P heatsinks?
If so, I would like one to the following specs:
heatsink (v5 thermal glued version)
EZ Focus adapter (smooth)
Well, today turned out to be an unfortunate day. I left my newly built 462nm 2 watt laser in the center console of my car while I was eating. Sometime during my dinner the inner part of my laser's end cap popped loose and closed the circuit thus putting my laser in a constant on position. The...
I've removed several of the stock projector lenses from their holders. A two hour alcohol bath (ethyl) makes the job much easier. The alcohol will soften the glue and all that is needed after that is some careful work with pliers. I use two pairs and grasp on each side of the lens holder and...
I just hope the stock of these new diodes stays around. I had to sell off most of my laser collection so I could pay bills :-( So next year I am going to build a new 445 once my tax return comes in...
Hi Cad602, if the BDR-S06J is the same diode from the LG 10x Blu-ray writer then I can say it will easily handle around 550mA as long as it is properly cooled. I had one running at 575mA producing 750mW before I upgraded the diode to a BW512. I still have the original diode if anyone wants it.
Hi all, I just recently finished upgrading my old 10x 405 to a new BW512 405. I'm pretty impressed with the results:
847mW @ 575mA
Here's my equipment list:
SolarForce L2P host
Jayrob SolaForce heatsink
Aixiz module
405-G-1 lens
Microboost driver
Samsung ICR 18650 battery
I used a LaserBee...
I've been getting my 405s from Rayfoss lately. The last one I received was this one www.rayfoss.com It produces over 830mW with 546mA from a Microboost driver.