Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

[Pic Heavy] My DIY LPM by Kalmito

Joined
Jan 4, 2012
Messages
69
Points
0
I need to connect 10x10 Ohm SMD resistor to series or Parallel Connection ? How thick is the plate ?

lm317pinout.gif


Which the S pin ?
 
Last edited:





honeyx

0
Joined
Jun 12, 2011
Messages
377
Points
28
I need to connect 10x10 Ohm SMD resistor to series or Parallel Connection ? How thick is the plate ?

lm317pinout.gif


Which the S pin ?

You solder the 10 resistors in series so they look like an "S". There you get an 100Ohm resistor in form of an "S". This one you are going to glue on the aluminum plate. The plate should be about 1-2mm thick.

So 100Ohm*0,050A= 5V and 5V*0,050A=0,250W or 250mW.

at 100mA you get this:

100Ohm*0,100A=10V and 10V*0,100A=1W.

You can of course use an constant voltage source for this too but a constant current source is better and more accurate.
 

honeyx

0
Joined
Jun 12, 2011
Messages
377
Points
28
2.JPG


This is about what I mean. But rather than glueing the resistors directly on the TEC like a ring in form of an "U" I did it on a aluminum plate in form of a "S".
 
Last edited:
Joined
Jan 4, 2012
Messages
69
Points
0
This is about what I mean. But rather than glueing the resistors directly on the TEC like a ring in form of an "U" I did it on a aluminum plate in form of a "S".


Yes Yes! I understand! :)
Thanks Brother!Its very good!
I need to buy DC PowerSupply to set the voltage and milliamps.
 




Top