- Joined
- Feb 12, 2014
- Messages
- 14
- Points
- 1
Hi to everybody, first of all i have to thank you guys for the good work providing information on any level for lasers ,and since my first baby died by excess heat after some (?12/15?) hours of continues operation (i forgot it on :yabbem: ) now i am thinking to take one of tose great 445 M140 +CU module from DTR's ebay shop and since i do not want to make mistakes this time i will shot some stupid noob questions....
well mi list of objects that next week i will get is:
1.5-2W 445nm Blue Diode in Module W/Leads & Aixiz Glass (
i think that if DTR looks upon his site stats he can see that there is a user online since 1 week ago and will be so,until the M140 will arive to my home :crackup:
)
12X30mm aluminum mount for AixiZ 12X30mm units
and of course a driver, since this time, whit a serius LD like an M140 i do not want to risk blowing it for stupid mistakes
this is the driver i am planning to use
so,now the questions![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
the aluminium mount that i buyed how much (roughly) time of continuos operation can give out of a M140 driven at 1300mA without damaging the laser?
it is better an active cooling system at that power or maybe only a passive tipe for the LD?
@DTR, there is a post were you put a lot of photos of the diode been pushed to max (from tot mA to a max of (?) i do not remember) can you please link me that post,i cannot find it ?
i am trying (nearly finished) to make a CNC laser cutter/engraver using an arduino and pololu drivers, but since my GRBL goes on a max feed of 100mm/m i think the laser may overheat very quikly and burn before finishing the design. any help will be very apreciated
waiting til tomorrow to get the camera so i can post some picture of the cnc and a custom invented heatsink that maybe can do its job
whit a antisplash
focusing ring on it, since i read a post here on LPF that talks about a litle splash effect on the aixiz glass lensens.
thank you and please excuse my bad english :yabbem:
well mi list of objects that next week i will get is:
1.5-2W 445nm Blue Diode in Module W/Leads & Aixiz Glass (
12X30mm aluminum mount for AixiZ 12X30mm units
and of course a driver, since this time, whit a serius LD like an M140 i do not want to risk blowing it for stupid mistakes
this is the driver i am planning to use
so,now the questions
the aluminium mount that i buyed how much (roughly) time of continuos operation can give out of a M140 driven at 1300mA without damaging the laser?
it is better an active cooling system at that power or maybe only a passive tipe for the LD?
@DTR, there is a post were you put a lot of photos of the diode been pushed to max (from tot mA to a max of (?) i do not remember) can you please link me that post,i cannot find it ?
i am trying (nearly finished) to make a CNC laser cutter/engraver using an arduino and pololu drivers, but since my GRBL goes on a max feed of 100mm/m i think the laser may overheat very quikly and burn before finishing the design. any help will be very apreciated
waiting til tomorrow to get the camera so i can post some picture of the cnc and a custom invented heatsink that maybe can do its job
focusing ring on it, since i read a post here on LPF that talks about a litle splash effect on the aixiz glass lensens.
thank you and please excuse my bad english :yabbem: