Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Noob screw up not azixa module what to do

vortish

vortish

0
Joined
Feb 24, 2014
Messages
1,425
Points
83
ok but were do the wires go there is just a little hole in the bottom of the brass piece
 





Polonium210

Polonium210

0
Joined
Nov 8, 2011
Messages
404
Points
28
That is where the wires go...

14147385913_92ddcaf338_c.jpg


Edit: I think your diode sits face down ON the brass ring and that holds the diode in the groove on the back half.. It is REALY hard to tell from your pics, I'm just going on a hunch from experience.
 
Last edited:
vortish

vortish

0
Joined
Feb 24, 2014
Messages
1,425
Points
83
ok I understand that but the wires will not fit through that little brass bit
 
Polonium210

Polonium210

0
Joined
Nov 8, 2011
Messages
404
Points
28
Place the finned heatsink half face down, insert brass ring, then diode face down on brass ring, wires sticking up through back half..
 
vortish

vortish

0
Joined
Feb 24, 2014
Messages
1,425
Points
83
sorry to tell you pol that is not it... I will just have to buy the real thing and hope i can find some one to buy these off me at what i paid for them 6.50
 
Bionic-Badger

Bionic-Badger

0
Joined
Oct 26, 2007
Messages
5,438
Points
83
Those module are actually quite nice and I often prefer them because you don't need a diode press or extra heat-sinking if you don't use them for very long.

Here's how you put the diode into position:

attachment.php


Just feed the wires out the hole in the screw-on backing, put the diode into the bottom of the hole, and tighten. Other modules that don't have a separate brass fitting on the back just get held in place by the screw-on back.
 

Attachments

  • 16mm_host.png
    16mm_host.png
    12.3 KB · Views: 135
You must log in or register to reply here.




Top