Wiring a AC brick for HeNe Laser

[icarus551]

Hi fellas,

I picked up one of these the other week:

The wiring on the input of the power supply has me rather confused, as I've only dealt with DC power supplies before. Could someone enlighten me on how I'm supposed to wire up the 2 white and green wires? The AC brick on Sam's FAQ has quite a few more wires than this one!

-thanks

 

[lasersbee]

If the input is 120V AC... and not DC then connect the
2 White wires to the 120VAC.
The Green wire is to be connected to the 120VAC Ground
pin.

Jerry

 

[icarus551]

Ahh right, thanks! ...For some reason I was expecting a more complicated solution..