- Joined
- Aug 18, 2007
- Messages
- 114
- Points
- 0
Lately ive noticed with my 30mW DX newwish that it has no output when its a bit cold. For it to fully light up it has to be heated up, holding down the button does this but this takes a few minutes while the intensity is flickering etc. Holding it in front of a heater is much quicker.
Is my laser faulty, i had a diffrent one a while ago and it was never this bad, when it was cold the output was a bit low but this one outputs nothing at all (not even a faint dot on the wall)
Cheers
Is my laser faulty, i had a diffrent one a while ago and it was never this bad, when it was cold the output was a bit low but this one outputs nothing at all (not even a faint dot on the wall)
Cheers