azamites
0
- Joined
- Feb 24, 2010
- Messages
- 11
- Points
- 3
Hello,
I have a Rayfoss IR filtered green LASER. When I received it as an exchange from Rayfoss, the beam was coming out at a slight angle and hits the aperture slightly which disfigures the beam spot. Since this is out of the one year warranty, I thought I might open her up and try to straighten out the module. Problem is there seems to be a clear hard plastic used to seal this baby shut. Does anyone know how to carefully remove the head in order to get to the module/heat sink so I can try to align it? Here is a photo of the LASER and the glued part. Any help will be appreciated!
I have a Rayfoss IR filtered green LASER. When I received it as an exchange from Rayfoss, the beam was coming out at a slight angle and hits the aperture slightly which disfigures the beam spot. Since this is out of the one year warranty, I thought I might open her up and try to straighten out the module. Problem is there seems to be a clear hard plastic used to seal this baby shut. Does anyone know how to carefully remove the head in order to get to the module/heat sink so I can try to align it? Here is a photo of the LASER and the glued part. Any help will be appreciated!
