I have this MI laser driver connected to my labby for battery operation. It works well, but I was wondering if it could run from a 7.2v RC Car stick pack or a 7.4 volt LiPo.
Website says 6v, and I have lost the instruction sheet that came with it. If anyone has the sheet it would be greatly appreciated. Also if anyone has run this off higher voltage without ill effects, info would be appreciated.
Worst case scenario is I use a few big diodes to drop the voltage. (3A 0.7 volt ones should be good)
Website says 6v, and I have lost the instruction sheet that came with it. If anyone has the sheet it would be greatly appreciated. Also if anyone has run this off higher voltage without ill effects, info would be appreciated.
Worst case scenario is I use a few big diodes to drop the voltage. (3A 0.7 volt ones should be good)
