Yes multiples quick ON OFF in a few seconds, looking for bad contacts in the switch.
It was shielded in a tube so probably not ESD.
Thanks. Will do better next time
My 488nm diode fryied, went very dim.
I increased the power to 200mA as diode heatsink wasn't hot ( saw a graph here where that diode was pushed double higher )
It seems to happened when switching ON-OFF-ON but it was also lukewarm ON for 3 minutes before.
So the 'driver' was just the voltage...
Thanks !!
7,62v x 0,110mA
0,83 W
Old 3mm thick resistor seems 1W
Can laser stays ON 100% duty cycle as long as brass heatsink doesn't go higher than 50°C ? ( datasheet says 60°C max )
I received my components and 488nm 90mA diode.
And did a quick try : adjusted the boost circuit to get 90mA in a 50 Ohm R.
Then I added heatsinked laser diode + Ampmeter to that loop.
Now there's 90mA going in the diode and it increase by only 2 or 3mA as the diode warms. It seems very stable...
Thanks ! I'll add a cap and use 125mA for low power cyan/green 6v diodes.
Now if I want to drive a red 3v diode at 700mA
R = 1.25/I -> 1.78=1.25/0,7
Then I use 1.8 ohm, and the boost at 8v ?
Big 5w resistor is needed ?
3v / 1.8 ohm =1.66A -> x 3v = 5W
I think I fryied a small pot...
One of my green dpss laser was doing the same dimming thing after one second. Luckily there was a pot on the driver, after lowering it a little, it doesn't dim anymore. It stays as bright all the time. (Even brighter than before)
Without pot may-be try lower input voltage
Is this simple design okay ?
Won't there be too much current inside the 0.15W potentiometer ? Because a 4w-pot is very large
Thanks!
(I'm waiting for my components)
Current will spike when switching On-Off ?
In my actual understanding, constant voltage would make constant current.
Like cranking up the voltage until desired current flows.
Hello,
I just discovered these dc step up boards rated :
3-5 v in
3-15 v out
1.2 a max
I'd like to use them to drive 6~8v diodes at 100~200mA from a single 4.2v li-on cell.
Do you think that tiny pot can be precise enough to set 100ma ?
Or is there major risk to fry the diode because of the...