Re: FS: Laserbee 2.5W USB LPM
Adding a laser host for sale!!
It's a stainless steel 26650 host with a copper heatsink and focus adapter! It's featured in the build I did awhile back link >here<
SOLD!!!!
:thanks:
Re: FS: Laserbee 2.5W USB LPM
Thanks for kind words everyone! It has been only used a handful of times. Sadly, I haven't had much time for my hobbies anymore. :cryyy:
Back in stock guys! Also, here's a little surprise!
The selectable test load HD
20A test load
100mΩ resistor to lower V drop at high currents
2 oz copper thickness for that extra current
deans connectors (30A capable) for diode selection
shin etsu thermal paste
heat sink can be swapped out...
Wow, I must have misread that post pman. For some reason I was thinking laser diodes. I have a table on my site for each jumper. It doesn't include the resistor voltage drop so just add that in. The table is based off the data sheet for the diodes used...
Hey guys I have test loads back in stock! However, due to a shortage of the usual diodes I use from the distributor I'll be using ON Semi 1N5404 diodes until they get them back in stock. They have about the same voltage drop and these were the same diodes I originally used when I first started...
Hey guys, I know this thread is quite old, but I have new and relevant information to share! I've owned this light for a long time and I just modded it. Took a while right? I was finally able to take out those stubborn screws that held the reflector in.
Here's a list of the mods I did...