Search results

X - Drives 1.8amp now back in stock!!!!! :wave::wave::wave:

Re: BlitzBuck V3, Available Soon! It should produce less heat if I'm not mistaken with higher Vin since the current draw would be significantly less, what kinda of current draw are you getting with 12VDC input? Oh and what setting are you at, 2.1amps output?

Try this way: Ultrafire WF-602c Laser Host & Heat Sink kit (silver) [ULTR602S] - $19.99 : Cajunlasers Store

Re: BlitzBuck V3, Available Soon! Nah I got a covered, wasn't your fault it aint werkin rite :o

Re: BlitzBuck V3, Available Soon! :bumpit: Before you know it you'll have a fully autonomous robot making these babies pumping them out like machine gun bullets! :na:

I'm basically giving away the last of these pocket mini kits :wave::

Re: BlitzBuck V3, Available Soon! Wolfman: I'm sending offroadfreak the last spare board I have on hand, as opposed to waiting on the return since he posted everything to see for us here. That way he can finish his build without further delay :san:

:beer: Once I get more free time here later on I plan on stocking back up, getting kinda busy with two little ones now ;)

Re: X-Boost V7 Mini (10mmx12mm) 1.8A Laser Driver That mini boost drive looks great! Count me in for some for sure! Lazeerer you're always coming up with something bad ass man ;)

You're welcome! Glad it arrived in one piece :D

Those are nice hosts, I have one awaiting me to build in it now actually ;) I'm sure Eud can cut those if anyone needed one now :) Thanks for the suggestion! I sorta leaning away from host kits in the near future actually, probably will mainly stock driver circuits.

I would suggest laser safety glasses either way just to be on the safe side, each marble is different so there's no 100% way to predict which direction and how concentrated each emission will be. They glow very bright green with a 405nm laser for sure.

:beer: Thanks!!!

New beaters are fun too! Your build looks great by the way! That old one just looks like something my former police sergeant (I'm an ex-policeman) would have carried on the beat back in his day. :D The good part about the mag-lights is you can always swap battery tubes for a 4 Cell one and...

Gonna have to upgrade those x-drive caps to handle 21 volts now! I bet you could polish that one up and turn it into a masterpiece :beer:

Woh! That looks like an old police issue thug beater! :evil:

Since DX has been out of the blue caps FOREVER I found a Chinese based seller that has them, but they're more expensive. I've bought some a few times just to have them in the store since no one else seemed to have them. The site currently is down for maintenance, without posting the link it's...

also on the way are some blitzbucks for the lower current ranges... :shhh:

Re: BlitzBuck V3, Available Soon! You could always try it at 1.2amps just to see what it does - that should pull less than one amp at 8.4vdc input. Assuming your 1 ohm resistor is still good to go.

Re: BlitzBuck V3, Available Soon! Would the two "jumper resistors" on that board in ARGLaser's photo make a difference since it looks like both ends of the two are jumpered? I think this may have come up before and I think you said it would matter, just noticed it in the photo however.