Search results

I did, hopefully I'll get a reply. Jake made a thread regarding the power of the IR, I figured I would add my questions as well.

Here is my brothers showing the internals Here is my laser showing internals Both are red lasers

You need the same stuff I believe for IR or Red or BluRay. Diode Lens/housing (usually aixiz for both) Housing for all of it (MXDL or flashlight or custom box) Driver (home build DDL or bought) Batteries, solder, soldering iron Electrical tape Possibly Hot Glue or heat shrink tubing

Jake and I are referring to the same drive.

AD-7190A

The open can and IR would be great if someone could answer. As well as which is the IR diode and which is the RED????

Which is the IR diode and which is the RED????

Anyone want any parts? The diodes are obviously mine but I will sell anything out of here, case, motors, lens, mirrors, dichro lens' Someone said they wanted the disc motor for R/C plane, someone please let me know who that was.

I got the lens and driver from pyrotronic on ebay but he is also on the forums here. Ebay Item number: 320215646746 The laser module is a open can 115d. You focus the beam by pulling the inner slide tube out, I'll take more pics of it. It is WAY WAY BETTER THAN AIXIZ for burning, but not as...

That's right you're the one that told me rechargeable, I should edit and give you full credit. It doesn't heat up much but you can feel it get warm but after a couple seconds it feels like it goes back to room temp. I don't think passive cooling like a heat sink will help much, I think a peltier...

http://www.laserpointerforums.com/forums/YaBB.pl?num=1203058543

100 assorted, I'll let you know if I want more.

I tested the mA right but I gotta retest the V, well I guess it is right when I have the ld hooked up

Before I put the diode in I put a 1 ohm resistor in and measured the voltage to get the mA. I took the resistor out and measured the volts, then I put the LD in and measured the volts again in parallel with the laser.

Re: FS: 180mW 650nm Laser Diodes - $25 you should have used a 10ohm tantalum, a 47uf will be impossible to fit i would think

1000uf cap w/ 10m ohm resistor

We tried 2 CR123's but it gives 6v to the laser and we tried that with a resistor but it didn't seem as strong as 3 AA's

With 3 AA's the circuits already 4v for some reason? But 3v when the laser is hooked up. I dunno, I think he wired something wrong but everything checks out and the mA is what it should be.

I have a 17yr old brother, I ordered a pioneer 115d diode pressed into an aixiz laser housing with a glass lens for my brother. I then went to radio shack and bought all the parts needed for a DDL driver. I taught my brother some electronics stuff and instructed him on what to do (he already had...