Recent content by VietTrader

@drlava Check your PM, please !!!

Yeh, it stops charging at 4.15V. After the the led indicator turn green, I check the battery, it's 4.15V. Then I leave the battery in charger 2 more hours, It's still 4.15V. (I tested both protected and unprotected batteries) I think my WF-139 is newer version, the voltage when don't charge...

My ultrafire WF-139 auto cut-off at 4.15V. I think it's a new version of WF-139.

When you use 1 ohm resistor, you will get 1250mA. You got 500mA because alkaline battery can't provide over 500mA. Try 3x lithium batteries in series (18650 or CR123A will be ok).

Oh, I miss some pics. I use the star caps from this green pen www.rayfoss.com

I done some build with this host before. This is very nice host.

Found some switch. Hope this'll help somebody else. McGizmo McClicky Pak Switch Module with holes no boot

Thank Grix. But they look like the same quality as DX's switch.

I try some switch on DX(DealExtreme: $4.30 16mm 101F Gold Plated Clicky Switch for Flashlights (10-Pack)). But their quality are poor, their resistance are 0.2-0.5ohm. Can anyone sell or suggest me some good clicky switch ?? Thanks !!

Blue one: Diode: A140 from Dave Driver: custom Current: 830mA Host: custom Rayfoss 100mW Green : Output: 110mW Divergence: 1.3mrad Beam Diameter ~ 1mm Beam divergence and diameter of original Rayfoss Green isn't very good (divergence ~ 1.7mrad, diameter ~ 1.5mm), I replaced the original lens...

@Pontiacg5 When did you ship my diodes ? And where did you ship from ??

My diode arrived. I love this blue. Thank Glenn !!

Do you mean my diodes have been shipped ?? I'm still not receive the email from paypal.

I canceled the Aixiz glass lens, and you refunded the lens cost. My order has just 1x diode installed in Aixiz module housing + insurance shipping.

Same Question !!:yh: