Recent content by Spyrius

I'd recommend testing the drivers you got with the lot first. Maybe try different combinations of 1 or 2 3V batteries using the diode bank with 1-ohm resistor as a load.

I'm pretty sure the 650's are the ones found in old DVD burners. I have used the 808nm to light matches on fire, but have never measured it on an LPM or had an opportunity to see it through NV goggles.

Good to hear.

Sold to LilDutchBoy7 pending payment.

Re: Proper 16340 Batteries for my 445nm 4W Laser Possibly. I'll let Lildutchboy7 have first dibs.

Yes. Although if you don't want the batteries I can take them out of the lot.

I haven't done anything with my laser hobby for a couple of years now, so I am selling everything except some of my favorite handhelds. I would like to keep the entire lot together and am asking $90 shipped. Photos and item descriptions below: Two green pointers between 5 and 50mW, and one...

Re: FS: Linear laser drivers + misc I'll take two of the linear drivers at the top of your post.

I've searched everywhere for laser diode drivers, but all the good ones were sold by people who have since left the business. The only ones I can find are DTR's X-Boost T-mini which is too expensive, and the Micro Boost Drive V1 which I've had bad experiences with. Where do you guys get your...

93401

How do you change the output current on this Driver? I have mine set on the 'low' setting, but how would I get it to output about 200mA from a 18650 battery?

I received my kit. Everything is there and looks great!

Payment sent via Paypal. Are we supposed to put down our order numbers?

Re: GB: C6 Copper heat sinks & focus adapters I'm in for two copper heatsinks and four aluminum focus adapters.

So 3x 10440s in series might work? Is there a special holder for that?