Hi, was it a bad idea to test the driver only with a test load on the red and let the green and blue unwired... I burned the prg chip when I started to play with the program buttons...
Now red is stuck at 179ma , blue at 189ma and green on 0
Can I buy only a program chip?
Thank you
Hi Glenn, I ordered one pressed in Axixz module w/ leads attached and Axixz glass lens,
but if anything missing or no time you can just send me the diode..it will be fine..
thanks!
That's a 5 years old wicked laser module with IR filter, changed the diode with a Stonetek 500mw IR, it's very bright at 330ma, I might push it to 400ma..I don't know...
Your are a star! Payment Sent.
now I have :
1 445
1 green dpss
1 650 nm with jayrob red lens, should be soon replace by the PL ML520G72 638nm 500mw GB.
1 Full Colour Driver on his way :bowdown:
and hardly waiting for the White Fusion Kit...:pop:
I'm planning to build a powerful portable RGB 2...
Hi!
Lucky you... I have my 3 diodes but still waiting a White Fusion Kit to be build... until then I'm practicing alignment with an old 803T sled:D
yes..dichro mirror inversed...
BTW does anybody have any refurb kit to sell, Sightfx seems to be in vacation and I don't want to pressure... :o
hey! the lens just arrived & tested yesterday, thanks!
Very clean & bright dot obviously compared to acrylic, sadly have no LPM...
I'm still waiting the great modified sled from Sightfx and the FML driver to see how far the blue and green will be pushed with still a good white balance.
Cant...
That's what I was expecting,
the original 808 of the pointer was giving a deeper dark, and I have just been surprised to see the red so easly at low current with this 803T. But It was written every where like a 808nm not a 760nm
actually I never look directly into the diode, I just watch the...