Yea Moh drivers are great, they offer everything one needs, but I'm on a super short budget and opening my possibilities of ordering this (sometimes included in flashlights) driver. With this, I can modify the resistor to output around 500mA ±50 and of course isolating the diode by using...
Thanks for the info, in this case for midnighttattoo. So were talking 4-5 total V.drop? What specific drivers do you recommend for input voltages of 2x 16340 7.4V?
Correct, voltage and electricity is just that, so the wavelength is totally useless, perhaps it was harvested from an 808 but doesn't matter. Also, if you plan to use 1x AA alkaline, I may be wrong but you may need to use a 'boost' driver that has voltage inputs of an alkaline 1.5v. I recommend...
Re: DealExtreme 200mW Diode Dead What ???
Well thanks for the input mate, good for those who own the specific and similar laser kits. The cost of those things are great.
Thanks for the input. So what specific drivers could I use for the LPC-826 aside from isolating it? By 'early shut down', I meant that when the voltage of the battery drops below 3 volts give or take the whole system shuts even though there is 80% of juice left, some posts described how by using...
Hello, I am building a red LPC-826 and have planned to run the diode off of this one driver. These diodes are meant to be powered no more than 500mA ±50, but I was told that drivers such as these could be used too? My plans are to run off of 2x 16340 (7.4v) to prevent early shut, instead of 1x...
:), thanks a lot guys. Read the heck out of everything before I decided to register and post for days, lol. Great forums, community and information here, I appreciate it.
Hehe, thanks for your input. I would also assume that the screw on part on the front of the flashlight host differs in size to accommodate the reflectors for the LEDs.