Recent content by Nae K

Sweet! Been a while since I've been on his site I'll pick one up, thanks :)

Can't imagine a laser turn on in my pocket lol... I've seen those sxd drivers around on ebay not the 1.8a they look really cool though. Def gonna look around for one.

I did not think of that, that's a good idea. Thank you :)

Hi guys, it's been a while I have been away from this forum :) But I was using one of my m140 diodes in dtr's copper hosts when it started being weird. So I opened it up to see that my positive pin on one side had snapped and the wire went with it. There was is a little bit of the pin left...

Thank you, I've bought from DTR before and he's really good so I'll for sure grab one off of his site. Thanks again.

I haven't posted here in a while! But I've been lurking, I have been using the LM317T circuit to drive my diodes. But from what I've seen and from what others have said it isn't very efficient. I don't care too much about it and could just go buy a prebuilt driver, but I was just curious if...

Never participated in one of these, but I'd be interested in getting two. :)

Woah you weren't like about especially big LOL. I doubt I have any that size lying around but I'll shop around. I'm pretty curious on that idea because as you saw in the first image that was just after a light press in the vise but the end result took a bit of force and I was worried about...

I'll have to try that out for the m140 diode I still have lying around, with the vise it is a challenge to keep it straight. I didn't think of channel locks but that sounds like a good idea.:unsure:

That's good to know, thanks again to everyone, I found one for 5.6mm press out, which for the time being I only have 5.6mm diodes so that checks out.

Ah I used the tool that came with the modules off of DTR's site, as I showed Lifetime in PM's this was the end result https://ibb.co/1frLGvJ But I'll have to check out some removal tools never hurts to have them in case I do mess up. Thank you.

Hey man thanks for the advice, I said it wasnt in all the way, that was before I pressed it flush with the vice ( I found a video that helped out really well). Thank you though, I pressed it a bit and realized it was crooked so I tried it again and realized it went in more it was a bit recessed...

I actually just pressed one of the multimode 1.5W diodes from Junktronix into a module from DTR last night https://ibb.co/Svhm5hv (Wasn't all the way in in the picture) But, I'm finishing a lm317 driver for it right now, are multimodes really that bad?

I've seen foam like the one you have described cut on a universal laser cutter, this was before I got into lasers so I didn't know much back then but it housed an IR laser module, I don't know exact wattage. However like Immo said, I was thinking other wavelengths would burn this material. As...

GPS(Global Positioning System) is think of if you have ever used google maps or apple maps for directions on where to drive that is an example of GPS.