Worrysome thread. Refund your product or resell it.. Even if the user wears protective goggles, has a beam dump (doubt it): You'd be a serious hazard to your enviroment who is not aware a lot of laser power is present in your room or outdoor enviroment.
IR lasers are some of the most dangerous...
Hi There!
To put it simply: I'm looking to buy a red hene laser.
.95mw or 1mw is completely fine
Most henes listed on ebay are either really pricey or show a blue light at the bore or look to be in a really rough shape.
Shipping preference goes out to somewhere in europe as I bet it's a...
Hey pyro, I was very happy with you 5.6mm diode press.
I'd love to buy the 3.8mm and 9mm version of those and while im at it also would like to buy your 3.8mm and 5.6mm and 9mm extractors.
Do you still sell them?
Components go through without any problem.. Galvos are even used in rapid camera tracking systems so not just lasers and aren't considered a dangerous product.
Avoid the ones on ebay... a lot of the "30kpps" systems on there lack the HFD (High Frequency Dampening) and cannot be properly tuned...
For most accuracy you'd like scannermax.. it has 2 modes of feedback you can set in software.. one high accuracy at lower rates (although still FAST) and the other lower accuracy at much higher scanrates (alhough still as accurate most galvanometer systems on the market). Engraving systems are...
This is a limitation of LD2000 intro. You need someone with (I believe basic) or for sure Professional to do it for you.
That or buy beyond essentials and import the show in there and do it in that.
Do note that import of LD2000 shows wasn't perfect in the past... I think it's way more refined...
hey flutterpie why not explore the wonder world of laser projectors using your pointers as source.. You might need to clamp them down and put heatsink compound or indium foil around them in a mount that would fit it but it might be an interesting entry into the laser world and keep you using...
Sorry for bumping an old thread. bought one and it shipped really fast.
Looks great so far.
However I'm not using an aixis holder but a small collimator.
The sleeve with the screw terminal does not fit over this.
Any ideas? :/ I really need to get these diodes recessed and pressed in firmly...
Can I buy one of the diode presses without going through ebay? (Saves you having to hand over a percentage of the sale too).
According to ebay shipping the item to The Netherlands it's 18$ which is a bit rediculous because the item costs 15$.
If the shipping is that high a friend of mine can...
Might be bumping something old here.
I'm interested in one 5.6mm diode press.
Will this work fine on non aixis housings that aren't threaded?
The thing is people told me to use the back of a aixis module but I think that the diode will be flush with this housing as the diode normally sat in a...