Lifetime17's latest activity

Hi LPF, Just need to know what your comments are on the 462nm / NDB7675/9mm diode . #1 What would be the suggested setting fir long life...

Hi, I would LPM those lasers ,but unfortunately I reside in the states. I would do it for free the only cost to you would be shipping...

Hi, Great choice more WL's and bang for your buck smart choices , Remember to post a thread upon your completion that would be great ...

The thread has been moved to the Vets section .. Rich:)

Hi, The first three links you posted are fine for what you need to do. And for that price you get three pens in different WL's. Rich:)

Hi . Yes Yes the 532 green would be perfect for what your intentions are. GSS hit the nail straight on go with the 532 its a bright...

Hi Great job, I did a few SA-305 Saik hosts looks like your build but only smaller. Rich:)

Hi Gary, Thank you for coming through for this member, great to have you on board here at LPF. Rich..

Hi, Yes I stated solder to to board were the CU is shown on the outer rim. the Al ring is just to hold the switch in place and make good...

Hi, The ring needs to make contact with the with board for grounding. Rich:)

Hi, Solder on the outer edge only the threaded ring is only to keep the switch in contact with the host, Rich:)

Hi Yes the 2x28650 501D is what you want Rich

H if you screw the thin ring off that holds the switch down you should see the copper on the outer edge of the contact board Just. Small...

How run some solder were the grounding edge touches the threaded ring. Then snug up on the ring Rich

If you think you are having a problem with your driver, you could post here - Drivers, Test-load, Power Supply, & Batteries.