Recent content by CrossOut

Good deal! thanks! i meant to keep it private as not to cause too much drama. but so be the case. I also added to that pm in response that the diode lips in and out of the diode pocket.. also a potential if thermal paste isn't used.

Ill mention this in a separate post since that last post of mine had over sized pics.. sorry about that. A few people have mentioned having problems with the plastic retaining ring which holds the clicky down. The issue is that the ring is too wide.. when assembled the rubber button will hold...

Hey Ken / Everyone else. I received mine after hunting down my previous room mate which it had accidently been shipped to. I must say im quite pleased these are both very beautiful hosts. PS kenom im having some issues with one of my grooves.. please check your pm

Did you get my PM about my address change?!!!!!!!! well i hope you did. if not i can pick it up from my old room mate.

Hey ken your at the end of the tunnel once you get out you can finaly devote all of your attention to your family. Best of wishes to you. Just a side note, did you get my pm about my recent address change? Just want to make sure. Thanks! I think you've done a great job despite all of the...

will you be selling the switches then?

AHHH!!! My green blue and blue purple look so SEXY Thanks kenommm!!

lolol a cooler for your cooler :D then it can be extra cool. dawg?

Tossing dry ice in there would create carbonic acid. that wont harm the process at all will it? Perhaps have the acid dip its self inside of a ice bath. maybe put the bucket in a cooler with ice in it.. if you have a cooler thatll probably be a cheaper option than to buy dry ice.. youll need...

Np ken, Please take your time.. I dont have any problems with waiting a few more months for a my groove :) I never ment to sound ungrateful i completely appreciate all of your hard work and effort going into these. please keep up the good work!

Heat the acid and add corn starch maybe? the heated acid will also react with the anodize faster so less can be used. at least in theory.

perhaps drizzle some on a piece of parchment paper and roll the barrel over it. you might be able to get a little more creative with this method as far as splash design goes. just remember that the nail polish will be the negative of what you want. anything under the nail polish wont come off...

I see. the process sounds pretty difficult. just a thought.. what would happen if you were to use a sponge and dab out the color? is it possible to turn the acid into a gel form? and as a final thought, what if you were to coat the barrel with clear nail polish (gloss) before applying the...

:( now i feel bad. Is it the same process as how you did the blue? i dont quite understand how the black and blue would have nice crisp clean edges to the splotching but the purple has fade. Yes please show more pics..

OMG!!! i got a hard on!!! are those mine? I checked the spread sheet IM BLUE!!!!!!! the green blue looks amazing. as does the blue and purple. the purple side of it looks a bit splotchy.. is there any way to clean it up? perhaps try again later down the line after more practice. If its not...