Camin
0
- Joined
- Feb 20, 2012
- Messages
- 33
- Points
- 0
I am building a DDL driver and when I went to test the voltage over the 1ohm resistor, I only got 11.7mV and if I changed the pot, nothing would happen. At first it I though it was the pot's fault, so I de-soldered it and flipped it around, then I tried a new one, but still have the same problem. Can anyone help me? I have included some pics.
The power supply is two 18650's I just realized they were only at 4V instead of 4.2, So I am going to charged them the rest of the way and try again. Any advice in the mean time?
The power supply is two 18650's I just realized they were only at 4V instead of 4.2, So I am going to charged them the rest of the way and try again. Any advice in the mean time?