Aurora C6 cree DIY has no battery board, what should I do?

[freeloader700]

I got the Aurora C6 cree DIY from DX see link

C6 DIY Cree LED Flashlight Full Casing/Shell with Driver Pill (2*CR123A/1*18650) - Free Shipping - DealExtreme

There was no battery board/contact with it. What should I do or use to get one there?

This is holding me up from my build and I am not sure what to do...

 

[azzman372]

I just bought a couple of these hosts too and found that they didn't come with the contact board either. So you have 2 options. Make one yourself out of some project board or veroboard Stripboard - Wikipedia, the free encyclopedia or ask someone to make you some like I did.
I was getting some stuff off flaminpyro and asked him to make some for the C6. They were really really cheap and fit perfectly in my C6 hosts. I'll post a pic later when I get home

Or you can buy a cheapy driver from DX and just rip the parts off it and find a soldering point to the terminal

Edit:
See this post I made about the veroboard or stripboard or protoboard
http://laserpointerforums.com/f38/405nm-kryton-grove-host-aurora-c3-67515.html#post973954