Recent content by kdubbz

WOW 3400 lumens on that 35watt one, nice and bright! I might have to save up for one of these.

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem nono, its ok you dont have to give me any money back. Ill experiment with it and in the mean time Ill have another o-like module in the mail. Thanks for the help though. And looks as if turning it counter clockwise helped, and it seems to not...

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem I tryed posting this earler but it was maintence mode. I turned it a 1/4 turn counter clockwise and the beam stays brighter longer than before, but once it dims and i turn it off and then on again it does it almost instantly like in the video...

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem Dident help. Can I send this to someone to see if they can tune it or somthing, or see whats wrong with it?

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem well, Im turning it off and on by lightly pushing the button in enough to turn it off, Ill try wire and battery method and report back. EDIT: Tryed it, still does the same thing. Its like is adjusts itself after I turn it on, is it supposed to...

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem Hmm, The laser keeps doing it now, guess it wasent from being cold. It turns on and its almost like someone is twisting the collimating adjusting it, I have a video im gonna upload soon. I Guess this one wasent meant to be. I Might upgrade to a...

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem Ok so I think I know why the laser is doing this, its because its cold as h#ll up here and once I warm it up in my hands or in the car it works fine. The cold is the culprit!

Re: FS: DIY Green Kit! Host, Heatsink - Easy Assem I dont know if this is normal, but I notice sometimes when I turn it on, about 2 seconds later it will dim down 2 times, like bright dims to dimmer, than dimmer again, probably about half strength. I turn it off and it does it again, turned it...

Re: Laser Barrels V2. GB. Second run. Kryton Groov just wondering, is it to late to get in on one of these?

Ok this next driver assembled much better with everything soldered on the back, minus the surface mount ones, I am more confident in this one, but it seems leaving a gap between the board and the head with the diode in it doesnt leave much room for a spring to sit inbetween the battery and...

Ok, I attempted my 1st PCB board, came out pretty bad and I dont trust it, How the heck am I supposed to solder the cap and resistors on the top when the solder pads are on the top? Can we solder the cap and resistors on the back? seems like soldering would be 100 times easier than soldering on...

Question, Does the negative connection of the pcb board need to be connected to the side with like a little piece of wire, or does it stay grounded through the ground of the diode that is connected to the whole alumnium case?

Yea, kenom do not take the money out of your pocket to order new parts and make new drivers, thats rediculus. I saw we wait it out, even though its been painstakingly long, till you get them. If not I am willing to throw down for new drivers to be made. Thats my opinion.

The cases look awesome! I cant wait for my 2 to come! i hope it will only be another month or so!