XCreedX
0
- Joined
- Jul 4, 2008
- Messages
- 347
- Points
- 18
Today I made two LM317 drivers, aka DDL drivers.
The larger one was my first build, used a LM317T, 2 10-ohm resistors, 200ohm pot, 1 1N4001 diode, and a 25mF capacitor, tops out at 108mA for a blu-ray.
Second one is my slim style build, as i gained some experience with building them, I could make it smaller and thinner. ;D
The driver utilizes a LM317T, 1 1ohm resistor, 1 1N4001 diode, and a 10mF capacitor, with a 200 ohm pot, tops out at 330mA, which is decent for a LOC.
My question is if i just did not use a resistor could i strike at least 420mA for a LOC?
I would appreciate comments and assistance.
The larger one was my first build, used a LM317T, 2 10-ohm resistors, 200ohm pot, 1 1N4001 diode, and a 25mF capacitor, tops out at 108mA for a blu-ray.
Second one is my slim style build, as i gained some experience with building them, I could make it smaller and thinner. ;D
The driver utilizes a LM317T, 1 1ohm resistor, 1 1N4001 diode, and a 10mF capacitor, with a 200 ohm pot, tops out at 330mA, which is decent for a LOC.
My question is if i just did not use a resistor could i strike at least 420mA for a LOC?
I would appreciate comments and assistance.