- Joined
- Aug 11, 2010
- Messages
- 360
- Points
- 0
So im obviously new here but I have been reading quite a few threads on the 445nm 1W diode and so I think I have most of it figured out but still have a few questions.
This is the parts list I have so far
The laser diode
Micro FlexDrive Driver
Big Heat sink - most should fit in the big Maglight host
Focusing Lens - Not sure what lens
Module - depending on the type of heat sink
Batteries - Not sure but the original flashlight takes several Ds so anything should fit
Do I have everything?
And now I have a few questions if anyone could be so kind as to answer them.
1. With that driver can I trust the preset current that I specify upon ordering? I plan to run about 900mA which I would imagine with a large heat sink and short duty cycle should be safe.
2. If using a heat sink how does one mount a focusing lens and what lens should be used? Should I just order the diode pre-mounted in a module and then find a heat sink to fit the module?
3. Will running the standard D batteries work fine or should I got with some other rechargeable battery?
4. Also do people use IR filters? I know the all the wicked lasers run them but I havent seen anything about them in peoples posts.
Thanks everyone in advance! Im excited to get this thing rolling and ill make sure to post lots o pics.
This is the parts list I have so far
The laser diode
Micro FlexDrive Driver
Big Heat sink - most should fit in the big Maglight host
Focusing Lens - Not sure what lens
Module - depending on the type of heat sink
Batteries - Not sure but the original flashlight takes several Ds so anything should fit
Do I have everything?
And now I have a few questions if anyone could be so kind as to answer them.
1. With that driver can I trust the preset current that I specify upon ordering? I plan to run about 900mA which I would imagine with a large heat sink and short duty cycle should be safe.
2. If using a heat sink how does one mount a focusing lens and what lens should be used? Should I just order the diode pre-mounted in a module and then find a heat sink to fit the module?
3. Will running the standard D batteries work fine or should I got with some other rechargeable battery?
4. Also do people use IR filters? I know the all the wicked lasers run them but I havent seen anything about them in peoples posts.
Thanks everyone in advance! Im excited to get this thing rolling and ill make sure to post lots o pics.