reginak
0
- Joined
- Sep 10, 2010
- Messages
- 207
- Points
- 28
Hi,
I just received a 600mW PL-C Jetlasers 532nm laser. (review later) Turned it on and it is BRIGHT, but now I have a question, when I asked Gray if the 600mW was after IR Filtering and he told me that yes, the output was AFTER IR firtering.
Quote from Gray:
So, I tested the laser on my LPM and the results were a little disturbing, average of 930mW and over 1W of peak. So I think I can conclude that the laser DON'T have a IR Filter. But how do I know for sure? Where I can easily get a IR filter? (I'm not in US).
Thanks
I just received a 600mW PL-C Jetlasers 532nm laser. (review later) Turned it on and it is BRIGHT, but now I have a question, when I asked Gray if the 600mW was after IR Filtering and he told me that yes, the output was AFTER IR firtering.
Quote from Gray:
...and yes, they're of course after the ir filtering...
So, I tested the laser on my LPM and the results were a little disturbing, average of 930mW and over 1W of peak. So I think I can conclude that the laser DON'T have a IR Filter. But how do I know for sure? Where I can easily get a IR filter? (I'm not in US).
Thanks
Last edited: