- Joined
- Jul 27, 2009
- Messages
- 46
- Points
- 0
Hey guys, I've been doing a little research and I decided it was time to attempt at a laser build.
I'm going to use the DX 4171 host (I'm assuming it's the new model, since I just ordered it), and I was going to use a PHR-803T diode. What I can't decide is to use a FlexDrive or rkcstr driver. I read that a rkcstr would be better for higher voltages (>5V?), but I'm not sure. Since we're on that subject, I could also use recommendations for which batteries to use. Finally, I was planning on using a Meredith module, and just so that I know I'm not completely confused, the module is basically the Collimating Lens (Meredith Instruments), right?
So, any tips or suggestions?
P.S. If you're reading this, jayrob, I'd also like to get a heatsink (for the 4171), if possible.
I'm going to use the DX 4171 host (I'm assuming it's the new model, since I just ordered it), and I was going to use a PHR-803T diode. What I can't decide is to use a FlexDrive or rkcstr driver. I read that a rkcstr would be better for higher voltages (>5V?), but I'm not sure. Since we're on that subject, I could also use recommendations for which batteries to use. Finally, I was planning on using a Meredith module, and just so that I know I'm not completely confused, the module is basically the Collimating Lens (Meredith Instruments), right?
So, any tips or suggestions?
P.S. If you're reading this, jayrob, I'd also like to get a heatsink (for the 4171), if possible.