rhd
0
- Joined
- Dec 7, 2010
- Messages
- 8,475
- Points
- 0
I'm looking for a handful of very simple heatsinks.
Basically, they would be 17mm square, with a typical 12mm hole in them. Depth would be 1cm. Precision is not required as these will be internal and non-visible. Similarly, surface finish is not important. Set screw is not required either.
In other words, if you can find aluminum stock that is 17mm square (16mm would be okay) and cut it into 1cm lengths, and then drill a hole through the center, that should work.
Let me know what this would cost if you have the ability to help!
Basically, they would be 17mm square, with a typical 12mm hole in them. Depth would be 1cm. Precision is not required as these will be internal and non-visible. Similarly, surface finish is not important. Set screw is not required either.
In other words, if you can find aluminum stock that is 17mm square (16mm would be okay) and cut it into 1cm lengths, and then drill a hole through the center, that should work.
Let me know what this would cost if you have the ability to help!