Gbb
0
- Joined
- Dec 26, 2014
- Messages
- 45
- Points
- 6
Hello i have a 200mw 532nm pointer here my little brother like 4 years ago when first purchased turned it on and left it on in the case when i came too it i was very warm to the touch, the heat sink is massive so it prob protected the laser a bit
the image is of my hand just above the beam,
i dont know if this is a divergence issue from it being left on and damaged?
or is this maybe dust on the lense or is this just normal and i didnt notice untill after
i was thinking of sending laser to be lpm aswell to see if power output has changed since i dont have one cannot tell
the image is of my hand just above the beam,
i dont know if this is a divergence issue from it being left on and damaged?
or is this maybe dust on the lense or is this just normal and i didnt notice untill after
i was thinking of sending laser to be lpm aswell to see if power output has changed since i dont have one cannot tell
Last edited: