Will This Work?

[360freak]

I want to start to build my blu ray laser. I want to pretty much do this http://www.laserpointerforums.com/forums/YaBB.pl?num=1209532949
but with a leadlight without the LED, since I haven't really found many except for on one site. For the AixiZ housing, I read about coated lenses, and they being coated for red lasers, and therefore reducing output. Will this solve the problem? http://cgi.ebay.com/Glass-lens-for-...5450694QQihZ002QQcategoryZ53141QQcmdZViewItem
Will this work with two aaa's totaling to 3v? I want to get a power of greater than or equal to 50mW. I have a PHR-803t diode. Will the voltage be too low to obtain this power? My only other aaa option that I know of is to use 2 3.7v batteries totaling to 7.2v, which looks to be too much for DrLava's Micro FlexDrive.

That pretty much sums up my project. Please point out any errors or concerns

 

[360freak]

I wanna start ordering my stuff asap.

 

[trublu832]

For your first build just start with a DDL driver and a few cr123's or a 9 volt battery. There are plenty of flashlights that will fit that combination.

 

[360freak]

I've already got it set that this is the pointer and driver that I want to use, I just want to confirm that it will work. I already have a Leadlight on the way anyway.

 

[john_lawson]

or get a 86 or 100 ma rkcstr driver 7 bucks each shipped then get a geek sled 26 bucks shipped and your pretty much set

 

[cbrian4]

I want to start to build my blu ray laser. I want to pretty much do this http://www.laserpointerforums.com/forums/YaBB.pl?num=1209532949
but with a leadlight without the LED, since I haven't really found many except for on one site. For the AixiZ housing, I read about coated lenses, and they being coated for red lasers, and therefore reducing output. Will this solve the problem? http://cgi.ebay.com/Glass-lens-for-...5450694QQihZ002QQcategoryZ53141QQcmdZViewItem
Will this work with two aaa's totaling to 3v? I want to get a power of greater than or equal to 50mW. I have a PHR-803t diode. Will the voltage be too low to obtain this power? My only other aaa option that I know of is to use 2 3.7v batteries totaling to 7.2v, which looks to be too much for DrLava's Micro FlexDrive.

That pretty much sums up my project. Please point out any errors or concerns

The glass lens is the worst one to get, its blue coated for reds. Stick with the stock aixiz lens