This is well-known I'm sure, but on the SXD, a wire is shown being soldered to the "enable" pin after removing a resistor. What should this wire be connected to? Any help will be greatly appreciated.
If you are not using TTL/PWM to modulate the laser you would ignore those instructions. Just lwire it with a positive and a negative lead to the input pads.
This is well-known I'm sure, but on the SXD, a wire is shown being soldered to the "enable" pin after removing a resistor. What should this wire be connected to? Any help will be greatly appreciated.
If you are not using TTL/PWM to modulate the laser you would ignore those instructions. Just lwire it with a positive and a negative lead to the input pads.
