For my next laser project, I was kind of thinking of saving a bit of money buy using this host:
http://www.dealextreme.com/details.dx/sku.12274 (Romisen 30mW).
Since there is already a heat sink, for 20 bucks I get a host and heat sink, just need the Diode+ Driver ( Would I need to get an Aixiz module?). Plus I get a green diode and driver I can use later.
Soooo....
25$ PHR-803T didoe
20$ Host+Heatsink (+Module?)
28$ Driver.
Not too bad. Now for the questions.
1. Will I need to get a laser module?
2. Using a Dr.Lava Flexidrive would the heatsink still fit around it? Would it fit and all?
3. How is the host? Any personal experiences?
4. Any flaws in my project?
Sorry for my stupidity. I am fairly new to lasers. :
http://www.dealextreme.com/details.dx/sku.12274 (Romisen 30mW).
Since there is already a heat sink, for 20 bucks I get a host and heat sink, just need the Diode+ Driver ( Would I need to get an Aixiz module?). Plus I get a green diode and driver I can use later.
Soooo....
25$ PHR-803T didoe
20$ Host+Heatsink (+Module?)
28$ Driver.
Not too bad. Now for the questions.
1. Will I need to get a laser module?
2. Using a Dr.Lava Flexidrive would the heatsink still fit around it? Would it fit and all?
3. How is the host? Any personal experiences?
4. Any flaws in my project?
Sorry for my stupidity. I am fairly new to lasers. :