- Joined
- May 15, 2010
- Messages
- 1,307
- Points
- 48
I've got a 405 build on the go and have a queery about the batteries. I am using a 3 AAA pill but that isn't going to provide enough power so I am going to use 2 10440's. The only problem i have now is wondering how to bridge the gap of the empty space. Do i solder a wire where the battery would go or how I have done it below
also using this driver
Laser Driver Board V1 - 80-500mA, optional TTL - Detailed item view - OdicForce Lasers Online Shop
I should be able to power the -ve in from the case pin of the diode right ?
also using this driver
Laser Driver Board V1 - 80-500mA, optional TTL - Detailed item view - OdicForce Lasers Online Shop
I should be able to power the -ve in from the case pin of the diode right ?
Last edited: