- Joined
- Jun 22, 2016
- Messages
- 2,686
- Points
- 113
Hi,
I'm looking for someone willing to help me to re-design BigClive RGB controller board size / PCB footprint to match MatekSys Mini Power Hub for stacking & space saving purpose. I'm currently designing open source RGB Host V2 and i'm looking help for this project.
RGB Host V2 should be smaller, shorter and more compact with 3x 18650's. New host should be only 26cm long and 50mm wide (by calculations ATM) if the RGB controller board new footprint (36x36mm) is doable...
Matek Mini Power Hub
- Dimensions: 36 x 36mm
- Mounting holes 30.5mm square spacing
And maybe 3x Low-Pass Filters for converting PWM Signal into an Analog Voltage for each channel (if there's enough space for those in 36x36mm board)
If you are able to this task and you are familiar to OSHPark e.g service, please PM me.
Thanks! :thanks:
I'm looking for someone willing to help me to re-design BigClive RGB controller board size / PCB footprint to match MatekSys Mini Power Hub for stacking & space saving purpose. I'm currently designing open source RGB Host V2 and i'm looking help for this project.
RGB Host V2 should be smaller, shorter and more compact with 3x 18650's. New host should be only 26cm long and 50mm wide (by calculations ATM) if the RGB controller board new footprint (36x36mm) is doable...
Matek Mini Power Hub
- Dimensions: 36 x 36mm
- Mounting holes 30.5mm square spacing
And maybe 3x Low-Pass Filters for converting PWM Signal into an Analog Voltage for each channel (if there's enough space for those in 36x36mm board)
If you are able to this task and you are familiar to OSHPark e.g service, please PM me.
Thanks! :thanks:
