My first 803T based Laser

[LiveRock]

Hi guys

Finally found some time to take some photos of my newly built 803T based laser....

Parts:
1. 803T diode in Aixiz module from ndrew25
2. Goove Driver from Dr. Lava
3. Black project box
4. Heat sink made up from spare parts and washers
5. Rechargeable 9V battery
6. LED with 500 ohm resistor for indicator
7. Charge socket for the 9V battery
8. Charge plug to connect to external 9V charger
9. Diode to prevent reverse polarity during charging.

The Photos:

[highlight]Laser Internals[/highlight]

You can see the Groove driver

[highlight]Front View[/highlight]

[highlight]Back View with the Charging socket[/highlight]

[highlight]Back View with the Charging cable plugged in[/highlight]

[highlight]Final[/highlight]

[highlight]Beam[/highlight]

 

[mike666]

Very nice.

 

[rog8811]

That is nice, I like the heatsink design...looks like a real gizmo

Regards rog8811

 

[LiveRock]

The heat sink is made out of one molded alloy material and washers!

Molded alloy material only cost $10

I know it looked intimidating; like a high voltage stunner