- Joined
- Aug 6, 2009
- Messages
- 476
- Points
- 0
Sup Guys,
Sorry I've been MIA for so long... But I'm back now! I put my hobbies to the side for a little while, so I could devote my time to my new car mods. I got a few of my mods done, so I decided to pick up my trusty soldering iron and rummage through my parts bin. This is what I came up with... Keep in mind these are old parts and spare pieces.. So please don't say "Oh you should of used a 9mm diode or a different driver and power supply etc..." lol .
Diode: A140 445nm
Driver: AMC7135 1400mA
Lense: G-1
Heatsink: Saik size Aluminum
Power Supply: 7.4 volt li ion battery pack 2000mah rechargeable
Output mW: 1300mW 1.3watts
It has a 450nm LED bezel just like my Saik build, and the charge circuit is built in. All you have to do is plug the power cable into the laser and then into the wall outlet.. when the green led goes off the unit is fully charged. I also wrapped it in carbon fiber. Looks Cool IMO
Thanx for looking!
-Sarge
Sorry I've been MIA for so long... But I'm back now! I put my hobbies to the side for a little while, so I could devote my time to my new car mods. I got a few of my mods done, so I decided to pick up my trusty soldering iron and rummage through my parts bin. This is what I came up with... Keep in mind these are old parts and spare pieces.. So please don't say "Oh you should of used a 9mm diode or a different driver and power supply etc..." lol .
Diode: A140 445nm
Driver: AMC7135 1400mA
Lense: G-1
Heatsink: Saik size Aluminum
Power Supply: 7.4 volt li ion battery pack 2000mah rechargeable
Output mW: 1300mW 1.3watts
It has a 450nm LED bezel just like my Saik build, and the charge circuit is built in. All you have to do is plug the power cable into the laser and then into the wall outlet.. when the green led goes off the unit is fully charged. I also wrapped it in carbon fiber. Looks Cool IMO
Thanx for looking!
-Sarge