Xer0
0
- Joined
- Dec 2, 2008
- Messages
- 464
- Points
- 0
Yesterday i was a bit bored in a lecture... so i took a sheet of paper and designed a bit:
* click on the picture for full sheet with all other concepts *
This mount would be able to correct alignment on all axis.
Up, Down, Pan, Tilt and Rotation!
But it is a bit tricky to build an needs two times the screws and springs of a default mount...
So what dou you think of my little Experiment, guys?!
* click on the picture for full sheet with all other concepts *
This mount would be able to correct alignment on all axis.
Up, Down, Pan, Tilt and Rotation!
But it is a bit tricky to build an needs two times the screws and springs of a default mount...
So what dou you think of my little Experiment, guys?!
I will Have a DIY mount out in one week...stay tuned. 