DX labby for heatsink?

[Murudai]

Hey guys.

One of the many projects I want to do when I find the time is a nice blu-ray labby Hopefully at 150-200mW with no dutycycle.

And I was wondering, would a DX labby have a good heatsink I could use for this project? Like this one
? http://www.dealextreme.com/details.dx/sku.9865

Have any of you used a DX labby to build a DIY laser before?

 

[nvmextc]

This person used the module from the heatsink I think. so it would fit. http://www.laserpointerforums.com/forums/YaBB.pl?num=1216991498

 

[MarioMaster]

I've been wanting to do the same - I've had that 70mw laser module on order since June 15th - it just keeps getting backordered to a farther ETA date

 

[jamilm9]

i have 2 heat sinks from those lasers.

 

[rog8811]

I have used one of those with a NIR burner and one for a red burner, the aixiz module is an easy fit so a bit of arctic silver and a screw are needed for best contact.

Regards rog8811

 

[pocketfluff]

To make a laser with an unlimited duty cycle, all you need is the silicon thermal glue from dx at http://www.dealextreme.com/details.dx/sku.4579

I've run my open can red at 400ma for over an hour, glued to a FLAT heatsink for over an hour, with barely any appreciable warmth. If its for a labby then you don't need to bother with pre drilled heatsinks.