Dead Blu Laser

[tgo111789]

I bought a laser awhile back on the forum. Ran great, but I fried it. Anywho, its a 130mW MXDL using 175ma flex. I'd like to fix it, but I don't have the know how, or time. If you can message me an estimate (based on the worst case scenario) i'd appreciate it. Im definitely willing to pay someone to fix it, I'm US, so if your US its better.

 

[daguin]

I bought a laser awhile back on the forum.  Ran great, but I fried it.  Anywho, its a 130mW MXDL using 175ma flex.  I'd like to fix it, but I don't have the know how, or time.  If you can message me an estimate (based on the worst case scenario) i'd appreciate it.  Im definitely willing to pay someone to fix it, I'm US, so if your US its better.

Send a PM to Gooeygus

http://www.laserpointerforums.com/forums/YaBB.pl?num=1227772783/0

Peace,
dave

 

[Mohrenberg]

I bought a laser awhile back on the forum.  Ran great, but I fried it.  Anywho, its a 130mW MXDL using 175ma flex.  I'd like to fix it, but I don't have the know how, or time.  If you can message me an estimate (based on the worst case scenario) i'd appreciate it.  Im definitely willing to pay someone to fix it, I'm US, so if your US its better.

it probably fried due to the simple fact that it's being pushed? assuming it was using a phr-803t diode.
it's best to run these at 120mA..you might want to have gus lower the output so it doesn't happen again.