jArdi
0
- Joined
- Jan 21, 2013
- Messages
- 142
- Points
- 18
been some time since i've posted. No money for more lasers atm 
anyway, recently (few months or so) i bought a 100mw green keychain laser from lazerer (which i must say was a horrible experience. The only reason i would ever buy from them again is because i like the SMALL lasers)
The whole thing was made extremely cheaply (didnt expect this bad), but thats sort of unrelated (kind of)
well yesterday, the laser dropped off the table, landed hard on the floor. The crystal didnt brake THANK GOD, but its casing (not sure what its called, i think the intracavity; the brass disk part where the mirror and the crystal with the white glue is held) broke off where it was glued in. Now i managed to take the whole thing apart, and glue it back on close to where it was, but idt i got it in the best possible spot.
So no im curious as to how you guys suggest lining it up, and gluing it. Any suggestions?
hope im not sounding like a complete idiot :tinfoil:
anyway, recently (few months or so) i bought a 100mw green keychain laser from lazerer (which i must say was a horrible experience. The only reason i would ever buy from them again is because i like the SMALL lasers)
The whole thing was made extremely cheaply (didnt expect this bad), but thats sort of unrelated (kind of)
well yesterday, the laser dropped off the table, landed hard on the floor. The crystal didnt brake THANK GOD, but its casing (not sure what its called, i think the intracavity; the brass disk part where the mirror and the crystal with the white glue is held) broke off where it was glued in. Now i managed to take the whole thing apart, and glue it back on close to where it was, but idt i got it in the best possible spot.
So no im curious as to how you guys suggest lining it up, and gluing it. Any suggestions?
hope im not sounding like a complete idiot :tinfoil: