Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



Laser Pointer Store

Can someone build this aluminum mount?

Joined
May 13, 2010
Messages
18
Likes
0
Points
0
Ok, I am submitting a design for a heatsink/mount that I need built for a processing chip. It is roughly based on an aluminum block that I have but I need it with some slight modifications. It is not for a laser but the project I want to use this for requires lasers.

Here is the aluminum block that I currently have:







There are two 1/4-20 sized screw holes on the bottom where I screw in two shafts to mount onto a table:








This is the new design that I want built. It is slightly bigger and has an extruded box where the hole used to be. The screw holes are not in the model but I need them there for the shafts.



Ignore the little drill holes on the surface of the block. The block is 8 cm wide, 13.8 cm long, and 1.2 cm thick. All detailed measurements from my Autocad drawings are included in the pdf documents (you can hide/unhide measurements in the pdf's). The mount needs to be built to these exact specs with threaded 1/4-20 holes on the bottom for the shafts.

I really hope someone can make this. I need to have this piece to move forward with my project. Please send price quotes via PM and I'll take the most reasonable offer.

Any questions please ask. I try to be as detailed as possible.

Many thanks!
 

Attachments


Gryphon

New member
Joined
May 4, 2009
Messages
1,838
Likes
35
Points
0
It is not for a laser but the project I want to use this for requires lasers.
You say what now? :thinking:

There are a number of machinists here, one of them should be willing to help you

What will this end up becoming if you can have this piece fabricated?
 
Joined
May 13, 2010
Messages
18
Likes
0
Points
0
You say what now? :thinking:

There are a number of machinists here, one of them should be willing to help you

What will this end up becoming if you can have this piece fabricated?
It will serve as a mount for a DLP chip (Texas Instruments tech, blue-colored chip in my avatar). The extruded box thing will make contact with the backside of the chip where the switching mirrors are and will provide heatsinking and cooling. I am basically making a prototype DLP projector that uses lasers as a light source and I need a mount that both holds the chip upright and provide cooling at the same time.
 
Last edited:

Pontiacg5

New member
Joined
Dec 23, 2007
Messages
2,524
Likes
166
Points
0
I'll ask tomorrow what it would cost, but I usually don't deal with single item deals. It makes the price too expensive.
 
Joined
May 4, 2009
Messages
5,462
Likes
551
Points
0
Yes I can make this part for you, ask RKCSTR about that I just made him some car parts ;)
PM sent
 




Top