Fenzir
0
- Joined
- Jan 25, 2011
- Messages
- 699
- Points
- 0
Hi, I'm doing my first build and my plan was for it to be a 100mwish 405nm laser. This was cut short because upon removing the extraneous material surrounding my 803t, I broke off the positive and case pins . After learning from my mistake, on my second one I did a lot better of a job and the current runs through it fine . However, I would love for my first diode to work as well as it is already pressed into an Aixiz, any way to fix this? I did a search and some people mentioned "bridging" and "reversing", but I'm not sure how they mean. If anybody could help, it'd be fantastic.
I'll probably have some more questions about the build as it continues aswell, so I'll keep them all in this thread.
I'll probably have some more questions about the build as it continues aswell, so I'll keep them all in this thread.